bb.donnay-software.com

I have several large applications That print several hundred documents of 100 to 600 pages in length. All of the printing is done to a file with imbedded PCL commands and sent though a document handling system to our high speed printers. We print over 2,000,000 sheets a month. Alaska is taking 10 times longer than Clipper to print to the files. The following example takes 12.9 seconds in Clipper but 126.58 seconds in Alaska. Expanded to the size of our documents and print time becomes unacceptable. Has anyone else solved this issue. I'm thinking I will have to write my own DevPos and DevOut functions to handle the file I/O and speed up the printing.

PROCEDURE MAIN
LOCAL mFile := "TEST.TXT"
LOCAL i,j

LOCAL mTest := {"This is Test ",;
"This is Test 1 ",;
"This is Test 2 ",;
"This is Test 3 ",;
"This is Test 4 ",;
"This is Test 5 ",;
"This is Test 6 ",;
"This is Test 7 ",;
"This is Test 8 ",;
"This is Test 9 ",;
"This is Test 10 ",;
"This is Test 11 ",;
"This is Test 12 ",;
"This is Test 13 ",;
"This is Test 14 ",;
"This is Test 15 ",;
"This is Test 16 ",;
"This is Test 17 ",;
"This is Test 18 ",;
"This is Test 19 ",;
"This is Test 20 "}
CLS
WAIT "Start?"
?
? "Starting"

SET PRINT TO (mFile)
SET DEVICE TO PRINT

mStart := SECONDS()
FOR i := 1 TO 20000

FOR j := 1 TO LEN(mTest)
IF j == 1
@ PROW() + 1, 1 SAY mTest[j]
ELSE
@ PROW() , PCOL() SAY mTest[j]
ENDIF
NEXT
NEXT

SET PRINT TO
SET DEVICE TO SCREEN

WAIT "Time: " + ALLTRIM(STR(SECONDS() - mStart,10,2))

?
? "All Done!"
?

Doug -

This sounds like a question that needs to be sent to Alaska.

I suggest emailing them at support@alaska-software.com.

Roger

dougtanner wrote:

Code: Select all

			@ PROW() + 1, 1 SAY mTest[j]
		ELSE
			@ PROW() , PCOL() SAY mTest[j]

?

PROW() and PCOL() is very slow so use you own counter and try again ( see also PDR 4954 )

Roger,

I submitted my issue to Alaska Support. I'll let you know if I hear anything back.

Auge_Ohr,

I eliminated the PROW() and PCOL() function calls and the printing was just as slow. The issue must be imbedded in the DevOut() function. Thanks for the suggestion.

Doug

When I created my own DevPos() and DevOut() to print reports to a file, the time went down to 1.2 Seconds. From 12.9 seconds in Clipper and 126 seconds in Alaska. That is the solution I am going to implement. Users are always happy when you make the application runs 10 times faster. Ten times slower was unacceptable.

Most users are fickle. They quickly forget improvements and move on to something else to be unhappy about.

Doug

I got a response from Alaska Support. They pointed out that if I change to file to a local hard drive file, the time dropped to 2.15 seconds. I was able to duplicate those results and will change my program to now print to a local drive.

Doug

It sure sounds like an acceptable solution.